The Selkirk 5T-EL15KIT 5-Inch Ultra-Temp 15-Degree Insulated Elbow Kit is your best line of protection against chimney fires. It reduces the chance of hazardous flare-ups and possible calamities by keeping the pipe's outside surface colder. You may relax and savor the cozy warmth of your stove, knowing that your house and loved ones are protected.
This cutting-edge pipe serves two purposes: increasing your burner's overall effectiveness. By maintaining the exhaust gases at higher temperatures, it is possible to harness the power of heat and create a powerful draft. You will get the most use out of your stove thanks to the improved combustion caused by the improved airflow. Say goodbye to energy waste and welcome to a house that uses less energy.
Enjoy the comfort, savings, and peace of mind it provides in a single, elegant solution.
Pipe Inside Diameter: | 5" |
Height: | 3.06 Inch |
Outside Diameter: | 7" |
Material: | Stainless Steel |
Fuel Type: | Coal, Oil, Wood |
UL Listed: | UL-103 |
Elbow by Angle: | 15 (degree) |
Vent Construction: | Double Wall |
Pipe Type: | Elbow Kit |
The ULTRA-TEMP/GALVA-TEMP Chimney Systems that have been tested to the maximum temperatures required by Underwriters' Laboratories Safety Standard for Factory-Built Chimneys (UL®-103). This encompasses the ULTRA-TEMP® HT/GALVA-TEMP® HT chimney systems.
The Selkirk Chimney System (SCS) is designed to be an optimum choice for venting residential heating appliances that use fuels like wood, #2 oil, and both natural and LP gas. The SCS is particularly adapted for the latest, high-efficiency airtight wood stoves. It is intended for use with gravity (natural draft) and nonpositive internal pressure venting only.
If it is needed for use with an appliance having a power burner like an oil furnace, it can perform effectively, provided the appliance functions with neutral or negative draft at the outlet. However, non-residential appliances that may lead to positive pressure within the chimney are recommended to use a Selkirk Commercial Model PS or IPS system.
Selkirk Support Structures are precisely engineered with the capability to handle up to four times their maximum specified system weight at its maximum allowed height.
Support Table
Important:
Rule 1: The section of the chimney that meets the roof must rise a minimum of 3 feet above the roof's highest point.
Rule 2: Any segment of the chimney within 10 feet horizontally from a roof structure or surface must extend at least 2 feet above.
Step 1: Multiply the roof's pitch section by the distance in feet from the peak.
|
Roof Pitch & Chimney Height |
Selkirk Corporation, ("Selkirk", "we", "us", "our") warrants our residential Chimney & Venting products (* defined below) to be free from defects in material and workmanship.
For products installed after January 1, 2009, for a period of Ten (10) years from original installation, we will provide replacement product with a similar or like quality of available Selkirk product, free of charge, excluding any installation costs.
From the Eleventh (11) through Fifteenth (15) years, we will provide replacement product at a cost of 75% off the published Retail Price in effect on the date the claim is received, excluding any installation costs.
At expiration of the Fifteen (15) year term, we will provide replacement product at a cost of 50% off the published Retail Price in effect on the date the claim is received excluding any installation costs. This warranty coverage is non-transferable and applies exclusively to the original consumer.
No posts found
Click on the Add New button below to submit a question about this product. Please ONLY submit product questions. For all other inquiries, please contact us at 1-888-986-1535.